I don’t know why this hadn’t bothered us more with our T5.1 but almost the first evening we realised that shutting the sliding door from inside needed a big shove that resulted in things falling about. Bad enough when we are up and about but a real pain if one of us has to go out in the middle of the night!
Power latching is available as an option to the sliding doors and the tailgate on Transporters but it is only the sliding door that gives us a problem. It would have been a no brainier at £95 + VAT had we thought about it. I got in touch with Paul who owns the T6 forum because I had seen him offering a kit, it came to £430 for the motor, control module and wiring loom which sounds like a lot but the parts alone come to about £350 and then there is the loom and plugs. So a deal was done and Paul met us at Vanwest with the parts.
Now I had thought about waiting until July when we got back from our 6 week trip but I knew that having the parts back home heaving the door closed would annoy the hell out of us so I waded in. Removing the lower rear quarter panel was not easy because Andy @ Coastal Cussions had used military grade trim panel fixings but I got it off and only broke 2 of them. Perhaps the worst thing was that we had got Andy to cover the access panel in the C post over – we wouldn’t need to get in there again would we – with the vinyl trim. I started by cutting a half panel for the top half and then marking and cutting out the vinyl slightly smaller and then breaking out and cleaning away the ply panel I had bonded over the access. With that done I could fit the control module and I had intended to make a hole to pass the wiring loom out of the bottom of the C post behind the step to the connections under the passenger seat. The problem was that the C post is closed at the bottom and does not go right down. In the end we decided to take out the whole access panel and feed the loom behind the trim all of which worked fine.
Fitting the motor is a bit fiddly as it needs feeding into the space but to be honest that was about the easiest part of the whole job. Once connected and everything back in place the power latch works great. Just slide the door across into the lock and the motor powers it home the last bit – lovely. Replacing the 2 broken trim fixings was easy enough and we made a new ply access panel for the C post but covered in our frantic rather than vinyl which actually looks a bit smarter than the original vinyl.
The whole job took a couple of days and was a bit of a “mission”as Mirko would say but the end result definitely seems worth it.